Post by ironhat on Nov 13, 2014 20:18:03 GMT -8
I didn't know for sure where to start this, so...
It's time to give the cast iron tables on the power equipment
a little love by sanding the tables. It has been 3 yrs but they
have seen very little use since then but, they are beginning to
get dull. When I finally do sand them it's embarrassing to
see how much they had rusted.
So, getting to my question; Has anyone out there used the
highly touted (by themselves) Renaissance Wax for table
preservation? They brag about the micro-structure of their
wax permeating the pores meaning a better protective finish.
I've used Johnson's Wax up till now but, I'm new to disability
and it seems that I need to find ways of getting around some
of these time-demanding tasks. So, get back to me if you have
any suggestions - even if it's to take a long walk off a short
pier!
Later,
Chiz
)
